Designed with one central button and no-pinch height adjusters to allow easy, one-person setup and breakdown; just open the canopy, push the button, and adjust the height. DESIGNED WITH ONE CENTRAL BUTTON AND NO-PINCK HEIGHT ADJUSTERS TO ALLOW EASY, ONE- PERSON INSTALLATION AND BREAKDOWN; JUST OPEN THE CANOPY, PUT THE BUTT IN, AND MOVE IT.
Table of Contents
How do you erect an EZ Up canopy?
The frame should be placed in the middle of the desired area. The legs should be held in place by the person holding the other leg. The frame can be made from a single piece of plywood or from two pieces of wood glued together.
How do you set up a Z shade canopy?
Step backwards, stopping at full arms’ length, with partner, grasping two outer legs and lifting them off the ground. The Z-Shade frame should be placed in the center of the area to be shaded. Lift off the ground, then step backwards, stopping at the same height as your partner. Step back and repeat with opposite leg, then with the other one.
What is a tent fold card?
A tent card is a convenient, self-standing promotional unit created from printed and folded cardstock. Tent cards are designed to be placed on table tops, as well as counters, desks, or any other flat surface.
Tent cards come in a variety of sizes and styles, and can be used as a stand-alone promotional item or as part of a larger promotional package. Tent cards can also be printed on a wide range of paper types, including glossy, matte, acid-free, archival, water-based, laser-etched, etc.
How do you open Quickshade?
To spread the frame open as far as possible, pull out the legs at the same time. To allow room to open the leg, you need to step backwards.
How do you put a gazebo on?
Fix the canopy to the frame is the first thing to do when building a gazebo. Before stretching the entire frame out, you need to make the frame stand up and adjust some weight to one of the corners. Place the gazebo canopy over the partially open frame and align three of it’s corners with the ground once the frame has been extended. Next, you’ll need to attach the roof.
To do this, cut a piece of 2×4 and drill a hole in the center of it. This will allow you to screw in two pieces of 1/4-inch plywood, one on each side. The roof will be attached with screws, but you can also use nails to secure it in place.